Unilin Click Rigid Vinyl Flooring With Wood Grain Surface Treatment

Unilin Click Rigid Vinyl Flooring With Wood Grain Surface Treatment

Description

Shire Unilin Click Rigid Vinyl Flooring With Wood Grain Surface Treatment​ ​is easy to installate ,this spc vinyl flooring is the new generation of floor covering, more environmental and durable .The main components are limestone (Calcium carbonate) and PVC resin and PVC Calcium-zinc Stabilizer and PVC Lubricant. Difference from LVC flooring, there is no plasticizer inside, so it is more environmentally friendly. Difference from Engineered Wood flooring and Laminate flooring, there is no glue inside, so it is much healthier. SPC flooring mainly structured with the UV coating layer, transparent wear-resistant layer, printing decoration layer, SPC Vinyl layer (the SPC core) and cork or EVA base.

Structure

Installation ways 

Tools and materials needed

· Utility knife & straight edge

· Measuring tape

· Shears for cutting around irregular shaped objects

· 1/8” spacers

· Transition moldings and baseboards

Installation

· Installation should begin with a corner and proceed from the wall with the tongue facing away from the wall. Allow a minimum gap of 3/8” (10mm) for product expansion. Transition moldings or baseboards will cover the gap.

· When laying the first row in a straight line interlock the short ends by inserting the tongue into the grooves at an angle of about 15 to 20 degrees. Install sequential plank on the short end (5.75”) and be sure to line up evenly. Place this first row along the chosen wall respecting the minimum gap by using spacers.

· Keep the seams tight between planks. You will feel and hear the click when locking the planks together to create a tight seam. There should be no visible gap between planks. If seams do not appear tight, pull the planks apart immediately and try again.

· When installing our SPC, it is strongly suggested to stagger the rows so that the short edge seams are not in a straight uniform line.

· To start the second row, measure and mark the plank, then using a straight edge and utility knife, score the plank and snap it.

· Interlock the first plank of the second row again at a 15-20 degree angle. For the next planks, interlock the short side first, leaving it slightly away from the long side and then slide it into the long side in the same manner. Start the third row with the last plank remaining from the previous row.

Specification

SPC  Flooring are not only manufactured from the highest grade materials but also resemble real natural patterns as closely and as realistically as possible.

Product Picture